
Koi38
Senior Member

Apr 2, 2007, 5:45 PM
Post #4 of 4
(888 views)
Shortcut
|
|
Re: [tonygeo] Returns Through liner?
[In reply to]
|
Can't Post
|
|
Hi What is the best way to pass 1 1/2 inch Pressure pipe through a liner as a pond return. Any help will be greatly appreciated. Thanks Tony Tony, It's easy mate Cut the hole 1/4" smaller than your pipe, now push the pipe very slowly(to avoid ripping the liner at the same time will give you a tight fit) from pond side to outside. You'll notice the outside part of the liner will form like a sleeve, you then use a ring clamp(must be marine grade) and tighten it very slowly. You can add a layer of liner over to prevent the clamp from tearing the liner while you're tightening it You can use silicon after not before rgds, Jon "DuKu Friendly" _____________________________________ "No one is ever too old to know better" http://s3.photobucket.com/albums/y63/Koi38/
|